Hi-pot Type Testing Application Note
This Application Note was written to provide insight into the one time requirement for ‘type' testing of power supplies by the safety agency or manufacturer. It will assist in the interpretation of requirements for this testing and provide broad guidelines on exactly what is required of the manufacturer in this test procedure.
This application note is written primarily with regards to Class I power supplies that have a safety earth ground. At the end of the document there is a section that outlines the differences for Class II power supplies.
Download to find out more.
Read More
By submitting this form you agree to XP Power contacting you with marketing-related emails or by telephone. You may unsubscribe at any time. XP Power web sites and communications are subject to their Privacy Notice.
By requesting this resource you agree to our terms of use. All data is protected by our Privacy Notice. If you have any further questions please email dataprotection@techpublishhub.com
Related Categories: Capacitors, Components, Power, Transformers
More resources from XP Power
Understanding AC/DC power supply efficiency – the hot topic
The drive for smaller power supplies goes handin hand with a need for greater efficiency. There' s a direct relationship here because the smaller t...
Parallel & Series Operation
It is much lower cost and causes far fewer problems to use a single power converter correctly rated for the application rather than two or more in ...
No load power consumption and efficiency legislation for external power supplies
Two important reasons for wanting to control the power taken by an external power supply are continuity of the energy supply and reduction of envir...
